Installation
operation
Maintenance & Care
a.
SE40520.
the HD lED
linkable strip light sensor
switch can be used as an
optional switching method
for the sE907
2
HD. the
light fittings then connect
back to the driver via the
sensor switch. sold
separately.
HD LED LINKABLE
STRIP LIGHT - 600mm
• Ensure that the power is disconnected prior to cleaning.
• to keep the finish of this product, wipe over with soft cloth periodically.
• Do not use harsh chemical solvents, it may dis-colour or damage the finish.
7
Finally wire the lED driver to 240V mains supply
or 13a plug top.
5
Multiple sE907
2
HD fittings can be
interlinked together to form a continuous
run of light.
once brackets are in place,
push the sE907
2
HD unit
into the brackets.
connect the lincus cable into the side of
the sE907
2
HD unit.
3
4
screw brackets securely.
2
Unit 7 Speedwell Road, Whitwood, Castleford, West Yorkshire, WF10 5PY
www.sensio.co.uk
technical drawings for illustration purposes only, sensio has the right to change any information
without prior notice. Make sure you check all hole cut outs before work commences.
2
6
Plug the white connector on the end of the
lincus lead into the 24V lED driver distributor
block. Beware not to exceed the wattage of the
lED driver, the max wattage will be displayed
on the 24V lED driver and on the light unit
fitting it will display the wattage requirement.
Mark-up and drill the holes in the
cabinet for the fixing brackets.
1
A
