furniture lighting solutions
1 x KAI
7
00MM SLIMLINE LED MIRROR IP44
Lay the mirror on a flat surface with the front glass
facing upwards. Using a Philips screwdriver, remove
the four screws, along with the metal and white
spacers on the sides of the mirror as shown above.
Carefully lift the mirror off the back box and position
it onto a soft flat surface to avoid scratching the
mirror. Pierce the small protective IP rated rubber
grommet (this will isolate and trap any steam to
ensure maximum safety during use).
ZONE
Inside the bath or shower
0
Musi
bf'
S
H
V
( 1
N max.)
due to water submersion
lvlm,mum rat,ng of IP67
1 ·- ... : .
• • I I I •. I
l I � .
2
The area stretch Ing to 60cm
outside
the
bath
or shower and
60cm from water outlet of sink- An
IP rating of at least IP44 is required.
This mirror is IP44 rated and
is suitable for installation in
zone 2 and the outside
zones.
Insert a 3-core cable through the pierced hole in the
protective cover, then thread the cable through from
behind the back box into the power supply. Mark the
position of the fixing holes in the metal back box onto
the wall, carefully avoiding any wiring or water
pipes. Next, drill and prepare the holes for the
screws ensuring that the wall is a solid material.
Mount the metal back box of the mirror onto the
wall and secure tightly.
Using a flat-bed screwdriver, securely connect to the mains
supply using the terminal block (incoming Neutral
(blue/black) to Neutral blue and incoming Live {brown/red)
to Live brown). To connect the LED's attach the male and
female connectors. For the demister pad, connect the
remaining male and female connectors together. Attach the
front glass panel safely onto the metal back box mounted on
the wall. Secure tightly using the 4 screws and spacers.
Switch on the mains electrical supply. To activate the mirror,
swipe your hand under the sensor switch.
OUTSIDE ZONES. Anywhere outside zones 0, 1 & 2. Where water jets are not used for cleaning purposes, the ge neral rules of BS7671 apply.
Maintenance & Care
• Ensure that the power is disconnected prior to cleaning.
• To keep the finish of this product, wipe over with soft cloth periodically.
• Do not use harsh chemical solvents, this may dis-colour or damage the finish.
Sensio House, Unit 7, Speedwell Road, Whitwood, Castleford, West Yorkshire, WF10 SPY
WWW.Sen S
j
O. CO.Uk
Visit our website for online instructions.
Technical drawings for illustration purposes only, Sensio had the right to change any information
without prior notice. Make sure you check all hole cut outs before work commences.
furniture lighting solutions
