Sensia QRATE Scanner 3300, Инструкция по установке, эксплуатации и обслуживанию

Страница: 68 / 92

• Shut Down Display.
Used to turn off the Android operating system putting Android in a halt condition. The intent
of this command is to turn off Android so you can power down the flow computer. This will causes the network
connection to stop functioning.
Note The flow computer may eventually time out and a restart will occur. This happens if power is not removed from
the QRATE Scanner 3300 after the touch screen display has been shutdown.
Enable/Disable User Configured Device Display Button
This button is used to enable or disable the user configured device display which shows selected real-time measurements
as well as status information for the device. When enabled The kiosk display will show the user configured device dis -
play and will either show or cycle between Flow Run 1 and Flow Run 2 (as shown in Figure 4.1, page 61 ). If disabled,
the display will show both flow runs at the same time (as shown in Figure 4.2 ) .
Configure Display Button
This will open up the options to configure the kiosk display settings.
Web Interface Button
This will open up the web interface for the device and allow the user to configure the device based on the installation and
purpose of the device. For additional information, see the QRATE Scanner 3300 Web Interface Manual.
Figure 4.2 - Touch Display; User Configured Device Display disabled
62
Section 4 QRATE Scanner 3300 integrated control flow computer