Sensia QRATE Scanner 3300, Инструкция по установке, эксплуатации и обслуживанию

Страница: 32 / 92

FCC Radio Frequency Compliance
QRATE Scanner 3300s that include the optional SmartMesh radio module comply with Federal Communications Com -
mission (FCC) radio frequency (RF) exposure compliance requirements when the following requirements are met.
Important To comply with FCC and IC RF exposure compliance requirements, the antenna must be installed
to provide a separation distance of at least 20 cm from all persons. Changes or modifications to
the installation that violate this requirement and are not authorized by the radio manufacturer
could void your authority to operate the equipment.
The SmartMesh radio has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a resi -
dential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, you are encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that used with the receiver.
• Consult the dealer or an experienced radio/TV technician for help.
IC Radio Frequency Compliance
QRATE Scanner 3300s that include the optional SmartMesh radio module comply with Industry Canada (IC) license-ex -
empt RSS standards. Operation is subject to the following conditions:
• The device may not cause interference.
• The device must accept any interference, including interference that may cause undesired operation of the device.
Radio Frequency Compliance Labeling
QRATE Scanner 3300s that include the optional SmartMesh and WiFi radio module comply with a broad range of coun -
try-specific radio frequency standards. The device wireless radio is approved for use in all of the regions listed on a radio
compliance label ( Figure 2.8 ) applied to the enclosure.
Figure 2.8 - Radio frequency compliance label applied to the QRATE Scanner 3300 enclosure (content may change
without notice)
26
Section 2 QRATE Scanner 3300 integrated control flow computer