Document
IMA0119
Rev
4
Page
4 (4)
Figure 3. Picture of the PCB with the jumper for setting current output (left position) or voltage output
(right position)
Self-diagnostics
The system contains a complete self-diagnostic procedure that is executed
automatically when the sensor is in operation. Sensors with display show a
wrench
if
an error is found. The wrench is shown during the first seconds after power up and if
the measuring range is exceeded. The output Out(2) indicates the same information
by setting the output voltage to 1V or 2 mA.
Maintenance
The
eSENSE
is basically maintenance free in normal environments thanks to the
built-in self-correcting
ABC
algorithm. Discuss your application with SenseAir in order
to get advice for a proper calibration strategy.
PLEASE NOTE!
The sensor accuracy is defined at continuous operation (at least 3 weeks after
installation)
PLEASE NOTE! Electronic products should be disposed of via a suitable
recycling centre.
This product is in accordance with the EMC 2004/108/EC, 92/31/EEG including
amendments by the CE-marking Directive 93/68/EEC
The product fulfils the following demands: EN 61000-4-2 level 2,
EN 61000-4-3 level 2, EN 61000-4-4 level 4, EN 61000-4-6, EN 61000-4-8 level 4,
EN 55022 class B
SenseAir
®
AB
(headquarter)
Stationsgatan 12
Box 96
820 60 Delsbo
SWEDEN
Phone: +46-(0)653-71 77 70
E-mail:
+
~
+
~
