FIGURE 2:
LED Front Control Panel
(a)
External power – “T” option:
120 VAC, 60 Hz connected to the unit.
(b)
Inverter power:
The green LED indicates that the SPS is operating from
batteries in “inverter mode”.
(c)
Low battery:
The red LED indicates that the SPS is in a low battery v
condition.
(d)
Overload:
The red LED indicates that the SPS is in an overload condition.
(e)
High temp:
The red LED indicates that the SPS has a high internal
temperature.
(f)
Bulk mode – “B3” option:
is in the bulk mode.
(g)
Accept mode – “B3” option:
charger is in the acceptance mode.
(h)
Float mode - “B3” option:
is in the float mode.
(i)
Condition mode -
charger is in the condition mode.
(j)
Check battery - “B3” option:
battery bank or DC cables.
(k)
Push to test – “U” option:
battery voltage LEDs as shown below.
(l)
28 – 30 VDC (Battery voltage):
(m)
26 – 28 VDC (Battery voltage):
(n)
24 – 26 VDC (Battery voltage):
(o)
22 – 24 VDC (Battery voltage):
(p) 20 – 22 VDC (Battery voltage):
c
b
e
a
d
f
g
h
i
j
8
LED Front Control Panel
“T” option:
The green LED indicates that there is external
120 VAC, 60 Hz connected to the unit.
The green LED indicates that the SPS is operating from
batteries in “inverter mode”.
The red LED indicates that the SPS is in a low battery v
The red LED indicates that the SPS is in an overload condition.
The red LED indicates that the SPS has a high internal
“B3” option:
The green LED indicates that the battery charger
“B3” option:
The green LED indicates that the battery
charger is in the acceptance mode.
“B3” option:
The green LED indicates that the battery charger
“B3” option:
The green LED indicates that the battery
charger is in the condition mode.
“B3” option:
The yellow LED indicates a possible fault in the
battery bank or DC cables.
“U” option:
Pressing this button enables the appropriate
LEDs as shown below.
30 VDC (Battery voltage):
Green
L
ED.
28 VDC (Battery voltage):
Green LED.
26 VDC (Battery voltage):
Green LED.
24 VDC (Battery voltage):
Yellow LED.
22 VDC (Battery voltage):
Yellow LED.
28-30 VDC
26-28 VDC
24-26 VDC
22-24 VDC
20-22 VDC
Form 122067
The green LED indicates that there is external
The green LED indicates that the SPS is operating from
The red LED indicates that the SPS is in a low battery voltage
The red LED indicates that the SPS is in an overload condition.
The red LED indicates that the SPS has a high internal
The green LED indicates that the battery charger
The green LED indicates that the battery
The green LED indicates that the battery charger
D indicates that the battery
The yellow LED indicates a possible fault in the
Pressing this button enables the appropriate
k
l
m
n
o
p