SensaSound USA LLC TP800F user's manual
6
Single wiring is the most conventional connection.
1. Keep the terminal links in place, you can also use
bare wire to link the terminal.
2. Just connect one pair of terminals to the amplifier.
Always make sure the connection consistency of
terminal polarity.
There are 2 pairs of binding posts on the rear of TP800F so you can have several connected options.
Bi-wiring can improve the low-level details and overall
transparency.
1.Remove the terminal links from the speakers.
2.Connect one set of speaker wires to the upper
terminals on speaker and one set to the lower
terminals on speaker. Connect them independently to
the amplifier output.
Bi-amping allows you to use two amplifiers for greater
dynamics.
1.Remove the terminal links from the speakers.
2.Connect the upper set terminals on speaker to one
amplifier output and follow the same principle to do the
lower set terminals on speaker. We recommend you to
use identical amplifiers and identical gains.
1.Enter into the receiver’s setup menu and go to “speaker setup”. Select “small” for surround and center
speakers, and select “large” for floor standing speakers.
2.Choose the proper crossover point according to your speaker specification.
3.In the speaker distance menu, you should measure the distance between your speakers and your
mainly listening position, then input the distance into the menu.
4.When you set up the volume level menu, you should adjust the volume level carefully until each
speaker is at the same loudness and at a comfortable listening volume. A SPL meter can help you do the
setup more accurate.
Single–Wiring
Bi-Wiring
Bi-Amping
System Set Up