SensaSound C600 Classic Series, Руководство пользователя

Страница: 5 / 11

Bare Wire
1. If you choose to use bare wire, first separate your wire into two pieces and strip ½” of insulating
layer off from the end of each wire.
2. Twist the exposed copper strands until they are tightly unified.
3. Unscrew the binding posts cap in a counter-clockwise direction.
4. Insert the bare speaker wire into the hole of binding post and tighten it in a turning-clockwise
direction. Make sure that you will not insert the insulation section into the hole as it may
interfere the connection.
5. Note that there is a red (+) and a black (-) terminal on the rear of each speaker. Make sure that
you connect the positive (+) terminal of your amplifier or receiver to the red (+) terminal on your
speaker, and connect the negative (-) terminal of your amplifier or receiver to the black (-)
terminal on your speaker.
SENSASOUND C600 Classic
Banana Plugs
If you prefer to have a flexible location with different speakers, you can choose banana plugs
connection for a convenient connect and disconnect.
1. Most banana plugs has obvious color-coding for red (+) indicates positive terminal and black (-)
indicates negative terminal.
2. Insert the banana plugs respectively into the right end of binding posts on rear of speaker.
3. Make sure that the banana plugs are completely connected with the binding posts.
4. Connect the positive (+) terminal of your amplifier or receiver to the po) terminal on
your speaker and the negative (-) terminal of your amplifier or receiver to the negative (-)
terminal on your speaker.
3