The microphone capsule
The microphone capsule features an overmold which only serves as an anti-kink sleeve.
The microphone capsule itself is protected from moisture.
Cleaning after use
Remove the frequency response cap from the microphone
capsule. Hold the microphone by the cable and
not
by the
anti-kink sleeve.
Shake the microphone capsule to remove excess moisture.
Aqua
dest
Bathe the microphone capsule in isopropyl alcohol to loosen
make-up residues and other soiling.
Do
not
use a cloth or a bristle brush to clean the micro-
phone sound inlet.
Dry the microphone for approx. 12 hours. The microphone
sound inlet has to point downwards during drying.
The cable
The anti-kink sleeve on the connector and the microphone is designed to meet the highest
requirements in quality. The use of additional adhesive tapes or shrink-on tubes can dam-
age the material and reduce the service life of the cable.
Only use lavalier tape (LAV-Tape) to attach the cable to the skin.
Lavalier tape (LAV-Tape) is available as an original Sennhei-
ser accessory.
Cleaning after use
Use a cloth or a
fine
bristle brush and isopropyl alcohol to
remove make-up residues or other soiling.
NOTE:
Particular hints for MKE 1 -
musical (M) variants
Only use destilled water and a slightly damp cloth for
cleaning the cable.
When cleaning
be extremely careful, only use
low
pressure
, only clean little
sections at a time
.
Otherwise beads may occur.
Do not
use isopropanol! It may damage the surface of the
cable.
Aqua
dest
MKE 1 - Cleaning instructions 2/2
Sennheiser electronic GmbH & Co. KG
Am Labor 1, 30900 Wedemark, Germany, www.sennheiser.com
Printed in Germany, Publ. 09/19, 540099/A03
12 h
