Sennheiser L 1039-10, Инструкция по эксплуатации

Страница: 9 / 14

Charging the receivers
8 | L 1039-10
Charging the receivers
왘
Insert the bodypack receiver/transmitter with the BA 2015 accupack installed
into any of the charging compartments
2
until it locks into place with an
audible click.
The accupack is being charged. The status LEDs
3
and
8
indicate the charging
process.
When an accupack is fully charged, the charging process stops automatically.
Accupacks that are left unused for extended periods of time lose a percentage of
their electrical charge. This is independent of whether the bodypack receivers/
transmitters are stored in the charger’s charging compartments or not.
To make sure that you always use fully charged accupacks, we recommend the
following steps:
왘
Fully charge the accupacks for about 4-5 hours before use. Recharge the accu-
packs every 2 months at the latest.
If you store the bodypack receivers/transmitters outside the charger:
왘
Insert the bodypack receivers/transmitters into the charger as desribed above.
왘
Switch the charger on.
If you store the bodypack receivers/transmitters in the charger’s charging
compartments:
왘
Switch the charger off and on again.
When the status LED
8
of a charging compartment lights up green, the accupack
of the corresponding bodypack receiver/transmitter is fully charged.
When the status LED lights up red, the accupack is being charged.