Sennheiser EZX 60, Инструкция по эксплуатации

Страница: 13 / 27

11
Putting the EZX 60 into operation
When the battery is about to run flat:
• The LED
쐏
flashes three times every 5 seconds.
• A low battery warning (five beeps) is heard in the headset every
20 seconds.
• You have several minutes of battery reserve. When the battery is
empty, you first hear the five warning beeps and then a descending
sequence of tones in the headset. The headset switches off.
Switching the headset on
To switch the headset on:
왘
Press the multi-function button
쐃
for at least 5 seconds.
An ascending confirmation beep is heard in the headset and the LED
쐏
flashes twice. The LED
쐏
then indicates the current operating mode.
Searching mode The LED
쐏
flashes once every 5 seconds:
The headset is paired to one or several Bluetooth devices and tries to
connect to one of these devices.
Standby mode The LED
쐏
flashes once every 5 seconds:
The headset is paired to one Bluetooth device and connected but
– there is currently no active call or
– it has not been used for more than 1 hour.
Call establishment The LED
쐏
flashes three times every 4 seconds:
The headset is paired to a Bluetooth device and is currently establishing a
call connection.
Active call mode The LED
쐏
flashes two times every 4 seconds:
The headset is paired to a Bluetooth device and there is currently an active
call.
Establishing Bluetooth connections
If the EZX 60 is not yet paired to any device, see “Pairing the headset“ on
page 12.
���
쐏
5 s
When the LED
쐏
flashes three times every 5 seconds, the
battery is almost empty.
5s
5s
4s
4s
WARNING Danger of malfunction!
The transmitted radio waves can impair the operation of
sensitive and unprotected devices.
왘
Only use the headset in aircraft where wireless Bluetooth
transmission is permitted.
After switch-on, the headset tries to connect to the Bluetooth
device to which it was last connected. If this device cannot be
detected, the headset will go into standby mode.