Sennheiser EM 100 G3, Руководство пользователя

Страница: 15 / 30

Using the receiver
13
To switch the receiver to standby mode :
왘
If necessary, deactivate the lock mode (see page 14).
To completely switch the receiver off :
왘
Disconnect the receiver from the mains by unplugging the mains unit from the wall
socket.
Synchronizing a transmitter with the receiver
You can synchronize a suitable transmitter of the ew 100 G3 series with the receiver. During
synchronization, the following parameters are transferred to the transmitter:
To transfer the parameters:
왘
Switch the transmitter and the receiver on.
왘
Press the button
쐃
on the receiver.
“ Sync ” appears on the display panel of the receiver.
왘
Place the infra-red interface of the transmitter (see the instruction manual of the trans-
mitter) in front of the infra-red interface of the receiver
쐇
.
The parameters are transferred to the transmitter. When the transfer is completed,
“
” appears on the display panel. The receiver then switches back to the current
standard display.
To cancel the transfer:
왘
Press the STANDBY button
쐂
on the receiver.
“ ” appears on the display panel of the receiver.
“ ” also appears if:
– no transmitter was found or the transmitter is not compatible,
– no transmitter was found and the synchronization process was canceled after
30 seconds,
– you canceled the transfer.
왘
Keep the STANDBY button
쐂
pressed until “ OFF ” appears on the display panel.
The display panel then turns off.
When in the operating menu, pressing the STANDBY button
쐂
will cancel your entry
(ESC function) and return you to the current standard display.
Setting Transferred parameters
“ Frequency Preset ” Currently set frequency
“ Name ” Freely selectable name currently set on the receiver
“ Pilot Tone ” Current pilot tone setting of the receiver (“ Inactive ”/“ Active ”)
쐇
쐃
쐇
쐃