Adjustment tips
19
Adjustment tips
Synchronizing the transmitter with a receiver
When synchronizing the transmitter with a receiver, please observe the following:
Synchronizing the transmitter with a receiver – individual operation
Upon delivery, transmitter and receiver are synchronized with each other. However, if you
cannot establish a transmission link between transmitter and receiver, you have to
synchronize the channels of the devices:
왘
With your EK 300 IEM receiver, perform a frequency preset scan to scan the frequency
banks for unused channels (see the instruction manual of the receiver).
왘
Select a frequency preset on your receiver (see the instruction manual of the receiver).
The frequency of the frequency preset must be approved and legal in your country (see
above).
왘
Synchronize a transmitter with the receiver via the infra-red interface (see page 14).
This establishes a transmission link between the transmitter and the receiver.
Alternatively, you can set the channel on the transmitter manually:
왘
Make sure that you set the transmitter to the same frequency bank and the same
channel as the receiver.
Synchronizing transmitters with receivers – multi-channel operation
Network operation
In multi-channel operation, the transmitters are remote controlled via a PC running the
“
Wireless Systems Manager
” (WSM) software.
왘
Connect your transmitters and your PC in a network (see page 12).
왘
Switch your transmitters and your PC on.
왘
Launch the “
Wireless Systems Manager
” (WSM) software.
왘
Using the
WSM
software, prepare your transmitter for the frequency preset scan.
The RF signal of all transmitters is automatically deactivated.
For further information, refer to the instruction manual of your
WSM
software.
왘
With your EK 300 IEM receiver, perform a frequency preset scan and select an unused
frequency preset (see the instruction manual of the receiver).
왘
Only use a transmitter and a receiver from the same frequency range (see the
type plate on the transmitter and the receiver).
왘
Make sure that the desired frequencies are listed in the enclosed frequency
information sheet.
왘
Make sure that the desired frequencies are approved and legal in your country
and, if necessary, apply for an operating license.
Stereo Transmitter
Stereo Transmitter
Stereo Transmitter
Stereo Transmitter
Advantages of controlling the transmitters via the “
Wireless Systems Manager
”
(WSM) software:
• Detailed overview of all transmission and receiving channels
• Remote control of all transmitters in the network
• Combination of transmitters of different frequency ranges (see page 4).
