SCT-CTX-Pelco-Panasonic
Pelco RS-422 to Panasonic coax Code Translator
Size:
4.5" x 3.5" x 1.25"
Weight:
0.5 lb
Power:
9Volt to 15Volt AC or DC at 75ma
Environmental: Indoor use only
Sennetech, Inc. 6455 W. Bath Rd. Perry, MI 48872 U.S.A. Ph (517) 675 1150 Fax (517) 675 1151
The Code Translator receives Pelco RS-422 camera control code and converts it into Panasonic
up-the-coax code for a single Panasonic camera.
SPECIFICATIONS
www.sennetech.net
+
_
RS-422
Data In
Pwr
Pwr
Connect power to the Pwr
inputs. Do not connect
power wires to the Gnd.
n.c.
The removable mounting
clip can be snapped onto a
din rail or screwed to a
panel or wall.
Removable edge connector.
Insert a small screwdriver in
the upper slot to force open the
wire clamp. Push all the way in
to open fully. Place stripped
wire end(s) in the open clamp
and withdraw screwdriver.
High impedance looping
coaxial video connectors.
Pelco
Address Switches
The range is 1~256
An invalid setting will
cause the Error in-
dicator to light up
solidly.
Tx
Indicator
Flashs when
coaxitron data
is sent up the
video coaxial
cable.
Configuration Switches
Switch 1: Unassigned
Up:
Down:
Switches 2&3: RS-422 baud rate
2 Down 3 Down
2400
2 Up 3 Down
4800
2 Down 3 Up
9600
2 Up 3 Up
19.2k
Switch 4: RS-422 parity
Up:
Even parity
Down:
No parity
Switch 5: Unassigned
Up:
Down:
Switch 6: Coaxitron Test Pattern
Up:
Test On
Down:
Test Off
Error
Indicator
Flashes for
input code er-
rors. Lights
solidly for any
invalid ad-
dress switch
setting.
Video
Indicator
Illuminates
when video
sync signal
is detected.
Rx
Indicator
Flashs when
any data is de-
tected on the
input.
