Senix CSPX2-M, Руководство оператора

Страница: 20 / 76

EN - 20 WWW.SENIXTOOLS.COM
SAWING TECHNIQUES
WARNING:
The risk of the operation may occurs, such as
the sharp tree branches may cut the user's skin,
the blade of the unit may hurt the user's body.
Always wear eye, hearing, hand, foot and body
protection to reduce the risk of injury when
operating this unit.
• Make sure the chain is running at full speed before
touching the branch to be cut
• When removing branches, hold the pole saw at an angle
ranging from 0 to 60° in order to avoid being struck by a
falling branch. The saw should never be operated directly
above head.
• Saw off the lower branches on the tree first. By doing so,
it is easier for the cut branches to fall to the ground.
• At the end of the cut, the weight of the saw suddenly
increases for the user, because the saw is no longer
supported on the branch. There is the risk of losing
control of the saw.
• Only pull the saw out of the cut with the saw chain
running. By doing so, you can prevent it from getting
jammed.
• Do not saw with the tip of the guide bar.
• IMPORTANT! Use the shoulder strap! Always use the
shoulder strap when working with the equipment. Switch
off the equipment before you take off the shoulder strap
(risk of injury). And hold the pole saw firmly with both
hands.
• If any foreign object is hit or if vibrations occur, stop the
machine immediately. Disconnect the battery. Check that
the machine is not damaged. Repair any damage.
• For sawing off smaller branches, place the stop face
of the saw on the branch. This prevents unwanted
movements of the saw at the beginning of the cut.
While applying light pressure, guide the saw through the
branch from top to bottom.
• For sawing off larger branches, first make a relief cut.
Saw through 1/3 of the branch diameter from the bottom
to top using the top side of the guide bar. Then saw from
top to bottom for the other 2/3 using the bottom side of
the guide bar.
• Saw off longer branches in sections in order to maintain
control over the location of impact.
MAINTENANCE
WARNING:
Always remove the battery pack and let the
product completely cool down before performing
cleaning and maintenance work!
Always wear protective equipments such as
gloves and eye protections to reduce the risk of
injury when operating this unit.
Only perform cleaning and maintenance work
according to these instructions! All further works
must be performed by a qualified specialist!
When servicing use only identical replacement
parts. Use of any other accessory or attachment
may increase the risk of injury.
REPLACING THE SAW CHAIN AND
GUIDE BAR
WARNING:
When handling saw chains, always wear
protective gloves.
Replace chain when cutters are too worn to sharpen or
when chain breaks. Only use replacement chain noted in
this manual. DO NOT use any other bar/chain combination.
Always include new drive sprocket when replacing chain.
This will maintain proper driving of chain.
1. Place the pole saw body on a firm and level surface.
2. Loosen the sprocket cover nut to remove the chain
sprocket cover.
3. Wearing protective gloves, take off the broken saw
chain or the guide bar.
4. Wind the new saw chain around the new guide bar,
making sure that the teeth are aimed in the direction of
rotation. The chain should be properly seated into the
slot running along the entire outside edge of the guide
bar.
5. Loop the saw chain around the sprocket and locate the
guide bar by matching its hole with the fixing bolt on
the saw.
6. Put the sprocket cover on the original place.
7. Screw the sprocket cover nut, but not tight.
8. Adjust the chain tension according to the chapter
"ADJUSTING THE TENSION OF SAW CHAIN".
9. Fully tighten the sprocket cover nut to secure the
sprocket cover.
10. Check for the smooth movement of the saw chain.