USB PORT
CU
MICROO TG
-A--
CU
MICROB
-A-
CU
MICROB
-A-
The module is designed to exchange data according to the modes defined by the MODBUS protocol. It has a
micro USB connector and can be configured using applications and/or software programs. The USB serial port
uses the following communication parameters:
115200,8,N,1
The USB communication port responds exactly like the RS485 or RS232 ports with the exception of the
communication parameters.
EASY SETUP is the software to use for the configuration.
For further information go to the following website:
www.seneca.it/products/ze-4di-2ai-2do - www.seneca.it/products/z-4di-2ai-2do - www.seneca.it/products/ze-2ai
Check that the device in question is included in the list of products supported by the Easy Setup APP in the store.
5/8
Power supply and Modbus interface are available using the Seneca DIN rail bus, via the IDC10 rear connector, or
the Z-PC-DINAL-17.5 accessory.
RS485 GND
RS485 A
RS485 B
Power Supply AC / +
Power Supply AC / -
IDC 10
1
Back connector (IDC 10)
The illustration shows the meanings of the various
IDC10 connector pins if signals are to be sent via
them directly.
Power Supply AC
Ground
Power Supply AC
GNDSHLDG
ND
CANL
/ B
CAN
L / A
DI
P
SWITCH
Z-PC-DINAL2-17.5 accessory use
If the Z-PC-DINAL2-17.5 accessory is used, signals
can be sent via terminal boards. The illustration
shows the meaning of the various terminals and
DIP-switch position (found in all supports for the DIN
rail listed in Accessories) for the termination of the
CAN network (not used for the Modbus network).
GNDSHLD:
Connection cable signal protection shield
(recommended).
Android APP
configuration
PC software
configuration
