5/8
ASSEMBLY REGULATIONS
The device has been designed for vertical installation or on a DIN IEC EN 60715 omega rail. Avoid mounting the
device inside metal cabinets or on top of heat-generating equipment.
INSTALLATION ON DIN IEC EN 60715 RAIL AND WALL FIXING
As shown in the figure on the side:
1. Insert the hooks of the support for DIN IEC EN 60715 rail into
the corresponding slots on the back of the container.
2. Hook the support to the DIN IEC EN 60715 rail.
Alternatively:
1. Through the two holes on the support for DIN IEC EN 60715
rail it is possible to fix it to the wall with the two anchors
supplied.
2. MyAlarm2 can be fixed to the support by inserting the hooks
of the support into the slots on the back.
ASSEMBLY RULES FOR VERSION WITH GPS (OPTIONAL)
For optimal reception of the GPS signal given by the satellites, MyAlarm2 should be positioned in an area not
covered by metal structures. If this is not possible or if the satellite reception is no good, an optional external
antenna with 3m cable (code A-GPS) is available. Follow the procedure supplied with the package for the
installation of the external antenna.
SAFETY INFORMATION
MyAlarm2 has a terminal block inside its enclosure.
To access the internal terminal block of the device,
unscrew the screw at the centre of the black cover
positioned at the bottom of the enclosure and lift up.
In the side figure, the cover has been removed.
IMPORTANT: With the relay card, mobile wiring of
cables connected to terminals is not permitted. To make
the cables from the terminals safe, use the break-out
passages in the back of the enclosure. When the wiring
is complete, fasten the protective cover on the device
with the screw to prevent any accidental contact.
12 3
4 56 7 89 10 11 12
-
+
13