SENEC Wallbox pro s, Руководство по эксплуатации

Страница: 27 / 81

English
27
2. OPERATING INSTRUCTIONS
Operating the SENEC.Wallbox pro s is described in
detail below.
2.1 Cleaning the Wallbox
Never use aggressive cleaning agents (e.g. petro -
leum ether, acetone, ethanol or methylated spir-
it-based glass cleaner) when cleaning the SENEC.
Wallbox pro s and particularly the plastic window.
These agents could attack or damage the surface.
Use mild detergent solutions (washing-up liquid,
neutral cleaner) and a soft, dampened cloth for
cleaning.
2.2 Operation
2.2.1 Charging a vehicle
Charging process
1. Fully unwind the charging cable from the Wallbox.
2. Remove the cover cap from the charging cable
coupler.
3. Plug the charging cable into the vehicle.
As soon as you have plugged the charging cable
into the vehicle, the Wallbox switches to “ready
for operation” and the front illumination lights
up white. When the vehicle has requested the
charging process, the front illumination pulsates
and charging takes place. When the vehicle ends
the charging process, the Wallbox completes the
charging process. The front illumination lights up
white. These two operating states can repeat several
times during a complete charging cycle.
i
If an external blocking device is used,
the system checks whether an external
block (due to a key-operated switch,
for example) is active when the vehicle
is connected. The front illumination
lights up white with brief interruptions
(95% on / 5% off) and charging does not
take place until external enabling has
been issued. Once external enabling has
been issued, the front illumination lights
up with a steady white light until the
vehicle requests the charging process.
End of charging
When the charging process has ended, unplug
the charging cable from the vehicle and close the
charging cable coupler with the cover cap. Then
wind the charging cable onto the Wallbox.
The Wallbox switches to standby mode after
12 minutes to save energy.
1.8.3 Blocking device
• An optional external blocking device (e.g. key-
operated switch) can be connected to the internal
interface. Fig. X shows the blocking device
interface.
• If an external blocking device (e.g. key-operated
switch) is connected, the charging process is
not started until the external blocking device
enables it.
1.8.4 Configurable blocking device
• The SENEC.Wallbox pro s offers the option of
configuring two different operating modes for
the blocking device.
• The mode allows the charging power to be
reduced by remote access if necessary.
• Block factory setting for charging
Factory setting (switch S5/2) to OFF.
Opening the switching contact will block the
Wallbox (charging not possible).
• Configuration for reduced charging
Set switch S5/2 to ON.
Opening the switching contact will reduce the
charging current (to 8 A).
1.9 Environment
This device is used for charging electric vehicles and
is accordingly subject to EU Directive 2012/19/EU
on Waste Electrical and Electronic Equipment
(WEEE). It must be disposed of in accordance with
the national and regional provisions for electrical
and electronic devices. Old devices and batteries
must not be disposed of via the domestic waste or
bulky waste disposal system. The device should be
rendered non-functional before it is disposed of.
Dispose of the packaging material in the common
collection containers for cardboard, paper and
plastic in your region.
1.10 Declaration of Conformity
The conformity declaration and the CE marking on
the product are applicable in the EU member states.
The Declaration of Conformity can be downloaded
from the manufacturer’s website.