REMOVE the foot from the front of the ramp and place it at the back of the ramp. Align the slot
with the T Nut Hole and replace the M10 x 40 mm Button Head Bolt. Do not over tighten at this
stage.
TURN the ramps over and REMOVE THE S BOLT - THEN LOOSEN the + Bolt.
Manipulate the
sections until the Ramp Surfaces until you can see through the
“C” Hole. Place and M10 x 40 mm
Button Head Bolt through the C Hole BY FINGER to make sure you catch the thread (CROSS
THREADING IS EASILY DONE WITH A TOOL!)
Tighten these bolts and then move and replace the FOOT at the back of the ramp.
