SENDER SHAPE SHIFTER
200 – 350 – 500 STRAIGHT
DESIGNED FOR BIKES - SKATEBOARDS – SCOOTERS
Our New Sender Shape Shifter Ramps can be adjusted to have a Straight and Curved Transition!
These ramps are based on our NEW EASY ASSEMBLY design reducing the number of screws
required and making surface alignment SUPER EASY. With reasonable DIY Skills and some
Basic t
ool’s you should be able to go from Flat Pack to jumping in 30 minutes to 1.5 hrs.
You may have ordered the ramp with an exterior grade colour preservative on one face. It is
important to coat all other edges and faces with a clear wood preservative if you would like the
ramp to last and function properly. IF your ramp came in Natural Birch then you should coat all
faces and edges. Maintaining your product will greatly increase its life span. We recommend
treating your ramp annually and spraying bolts and T nuts regularly. Always bring your ramp inside
to dry after use. Wood can swell and jam. Some components have small tolerances to ensure a
strong stable structure.
Never drag your ramp around. Lift and place the ramp where you will jump to avoid damage to
ground contact points. You can use the ramp on all surfaces as long as it is flat and even and the
sides / feet do not sink.
ALWAYS CHECK YOUR RAMP IS PROPERLY ASSEMBLED BEFORE EACH TAKE OFF
Jumping can go wrong very quickly and lead to severe or even life changing injuries and damage
to you bike, skateboard, scooter and property. We recommend grass take offs and landing when
using a bike. Always wear a helmet, knee pads and gloves as a minimum. Ensure clear take-off
and landing space all around and if used on the street locate and jump in a safe place with no
chance of striking or being struck by a car, van etc.
