Quick Start Guide
TSS 6220
Form 8174B
Version 2.1
–
June 2020
Page 2
Figure 2: Rear Port Connectors for TSS 62221 chassis
1.
Redundant Power Connectors: Provides AC power connections for
powering the system
2.
IPMI Port: Can be used for remote server management, but not
normally used in the TSS 6220 operation
3.
eth0 Port: Network port for management and streaming.
4.
eth1 Port: Network port for management and streaming.
5.
eth2/3 Ports: Ports available only with the addition of optional card
adding either 2x RJ45 or 2x SFP ports
6.
VGA Monitor Output
Figure 3: Rear Port Connectors for TSS 62222 chassis
1.
Redundant Power Connectors: Provides AC power connections for
powering the system
2.
IPMI Port: Can be used for remote server management, but not
normally used in the TSS 6220 operation
3.
eth0 Port: Network port for management and streaming.
4.
eth1 Port: Network port for management and streaming.
5.
eth2/3 Ports: Ports available only with the addition of optional card
adding either 2x RJ45 or 2x SFP ports
6.
VGA Monitor Output
Establish a Web Connection to the TSS 6220
In order to access the TSS 6220 web user interface, it is necessary to establish
an Ethernet connection to the device. There are two alternative ways to connect
to or
set the device’s management IP address: using the pre-set management IP
address or connecting a monitor and keyboard to the server.
Using the Pre-Set Management IP Address
The Sencore TSS 6220 is shipped with the following factory settings for the
network ports:
eth0 Default IP Address:
10.0.20.101
eth0 Default Subnet Mask:
255.255.0.0
eth1 Default IP Address:
DHCP
In order to connect to the web UI, the PC used for setup should have
corresponding network settings. Connect a PC directly to eth0 using an Ethernet
cable.
For Windows, the network parameters are set in the
Control Panel
— Network
and Internet
— Network and Sharing Center — Network Connection —
Properties
— Internet Protocol Version 4 Properties
view, as shown in figure
4. Select the user defined address and
set the PC’s IP address to 10.0.20.60 and
the subnet mask to 255.255.0.0.
When the IP address of the PC has been set in the same subnet as the TSS
6220
’s factory setting, a web browser can be used to access the web user
interface at 10.0.0.61.
1
2
3
6
4
5
2
1
3
6
5
4
