AG 6000
– User Manual
Page 38 (122)
automatically detect whether the input is
DVB-S or DVB-S2.
Satellite
Frequency
C-Band: 4GHz
– 8GHz
Ku Band: 11.2Ghz
–
14.5Ghz
L-Band: 950MHz
–
2150MHz
Dependent on LO Offset
If LO Offset is set to 0 then L-Band
frequency is entered into the Satellite
Frequency dialog box. If LO Offset to set to
a pre-defined option then enter C-band or
Ku-Band frequency.
Wide Search
Enable
Disable
When Enabled the search range may be
extended depending on the symbol rate.
See appendix C for more information.
LO Offset
5150
9750
10600
10750
11250
The offset in MHz that the local oscillator is
operating.
Symbol Rate
Mode
Manual
Auto
The Manual option allows the user to
choose the symbol rate. The Auto option
automatically detects the incoming symbol
rate.
Note: Acquisition time may be longer in
auto mode, especially when the symbol rate
is below 1MSps or above 55MSps.
Symbol Rate
0 - 60
The symbol rate of incoming satellite signal
in Msps. Accurate to one decimal place
(ksps). Used when Symbol Rate Mode is
set to Manual.
PLS Code
0
– 262141
The AG 6000 has the ability to receive
satellite signals scrambled using PL
Scrambling. In order to receive the stream,
enter the value of the incoming signals PL
Scrambling code.
LNB Power
Off
13 VDC
14 VDC
18 VDC
19 VDC
The AG 6000 has the ability to provide the
necessary voltage to power an LNB. Select
the correct voltage to supply to the LNB.
22kHz Tone
Enabled
Disabled
Enabling or disabling the 22khz tone allows
the AG 6000 to trigger the LNB to switch
polarities.
Multistream State
Enabled
The AG 6000 has the ability to receive
multistream satellite signals. If the signal is