EN-6
EN
Electric Kettle
SWK 2080BK
2015
06/2015
BEFORE FIRST USE
1. Remove all packaging material from the kettle and its base.
2. Fill the kettle with clean water up to the maximum water mark. Boil the water and empty the
contents of the kettle. Repeat this process two to three times.
Note
:
To boil water in the kettle, proceed according to the instructions in chapter Using the kettle.
3. Now the electric kettle is ready for operation.
USING THE KETTLE
1. Set the desired length of the power cord. Push the power cord into the groove in the base. Place
the base on a stable, even and clean surface.
2. Fill the kettle with the required amount of water. The water level must reach at least the minimum
mark (0.5 l) and must not exceed the maximum mark (2.0 l). You may fi ll the kettle through the spout
or through the opening after lifting the lid. To open the lid, press the button located in the middle
of the lid. After fi lling the kettle with water, close the lid and push it down so that it is secured in
the closed position.
Warning!
Never fi ll the kettle if when is located on the base.
If the electric kettle is overfi lled, then boiling water could splash out.
3. Place the kettle on the base. Insert the power plug into an electrical power socket. Check that the
lid of the kettle is closed.
4. Start the kettle by moving the switch to position I (On). The kettle will be lit.
Attention:
Do not turn on the kettle if it is empty. The incorrect use of the kettle may negatively affect its
lifetime. If you accidentally turn on the electric kettle without water, the thermostat will, after
reaching a certain temperature, interrupt the electric circuit and the kettle will turn off. The
kettle can be used again after several minutes, as soon as its stainless steel bottom has cooled
down.
5. When the water starts to boil, the kettle will turn off automatically and the kettle light will
turn off. Before taking the kettle off the base, check that it has turned itself off automatically.
If it has not automatically turned itself off, turn off the kettle manually by moving the switch to
position 0 (Off).
Note
:
The operation of the kettle can be interrupted at any time by moving the switch to position 0
(Off).
6.
Pour the boiled water into a prepared container, cup or mug. Make sure that it remains in a horizontal
position when it is carried, particularly if it is fi lled all the way up to the maximum mark.
If you wish to open the lid to refi ll the kettle, fi rst empty all the contents of the kettle so that you
are not scalded by the escaping steam.
7. After you fi nish using the kettle, disconnect the power cord from the el. power socket. Empty the
kettle and allow it to cool down.
