EN-6
EN
Electric Kettle
SWK 102BL
2014
07/2014
BEFORE FIRST USE
1. Remove all wrapping material from the kettle and its base.
2. Fill the kettle with clean water up to the maximum water mark. Boil the water and empty the
contents of the kettle. Repeat this process 2 to 3 times.
Note
:
To boil water in the kettle proceed according to the instructions in chapter Using the kettle.
3. Now the kettle is ready for use and for preparing warm beverages, etc.
USING THE KETTLE
1. Set the desired length of the power cord. Push the power cord into the groove in the base. Place
the base on a stable, even and clean surface.
2. Fill the kettle with the required amount of water. You may fi ll the kettle through the spout or
through the opening after lifting the lid. Open the lid, by lifting the lid opener A
4
. The water level
must reach at least the minimum mark (0.5 l) and must not exceed the maximum mark (1.0 l).
Warning!
Never fi ll the kettle if it is located on the base.
If the kettle is overfi lled, then boiling water could splash out.
3. Place the kettle on the base. Insert the power plug into the an electrical power socket. Check that
the lid of the kettle is closed.
4. Start the kettle by pushing the “ON” switch A
5
towards the handle A
7
. The power On light A
9
will be lit.
Attention:
Do not turn on the kettle if it is empty. The incorrect use of the kettle may negatively affect its
lifetime. If you accidentally turn on the kettle without water, the thermostat will, after reaching
a certain temperature, interrupt the electric circuit and the power On light A
9
will turn off. The
kettle can be used again after several minutes, as soon as its stainless steel bottom has cooled
down.
5. As soon as water boils the kettle will turn off automatically and the power On light A
9
will
turn off. Before taking the kettle off the base, check that it has turned itself off automatically.
If it has not automatically turned itself off, turn off the kettle manually by pushing the “OFF”
switch A
6
towards the handle A
7
.
Note:
The operation of the kettle can be interrupted at any time by pushing the “OFF” switch A
6
towards the handle A
7
.
6. Pour the boiled water into a prepared container, cup or mug. Make sure that the kettle remains in
a horizontal position when it is carried, particularly if it is fi lled all the way up the maximum mark.
If you wish to open the lid to refi ll the kettle, fi rst empty all the contents from the kettle so that
you are not scalded by the escaping steam.
7. After you fi nish using the kettle, disconnect the power cord from the el. power socket. Empty the
kettle and allow it to cool down.