Sencor SWD 130, Руководство пользователя

Страница: 4 / 9

EN-2
Installation
Always check that you have good signal reception from your chosen location.
Every structural obstacle reduces the effective range between the doorbell and
the doorbell button.
When installing the doorbell button outdoors, locate it in such a location where
it will not be permanently rained on. Suitable is a recess in a pole or a similar
location. Never locate it inside a metal cover. We recommend smooth and dust-
free surfaces.
Clean the respective area (button installation area), remove the sticker on the
other side of the adhesive tape and stick it on to this area. Push the transmitter
down firmly to ensure secure adhesion.
The button may also be permanently mounted using screws. Pre-marked screw
holes are located on the inside of the cover. These can be used if you wish to
permanently install the doorbell button. It is necessary to seal the holes under the
screw head so that water does not enter through them.
Information about placing a name tag on the button: Use an alcohol-based
marker. If you use a sticker, never apply it over the bell icon.
Power supply
AC
Connect the AC receiver directly to a mains power outlet. The area around the
power socket must remain uncovered and freely accessible.