EN-6
EN
Vacuum Cleaner
SVC 7PE
Copyright © 2017, Fast ČR, a.s.
Revision 01/2017
C
1
Carry handle
2
Front wheel mechanism
3
Stabilising travel wheel
4
Vertical parking position
5
Stabilising travel wheel
1
2
3
4
5
ASSEMBLY
Inserting the hose into the air suction hole on the vacuum cleaner:
Press both the safety buttons on the end of the hose end and insert the hose end into the air suction opening on
the vacuum cleaner until you hear a „click“ . The hose is now secured in correct position .
Attach the holder to the telescopic tube:
Make sure to place the holder with the hose on the wider part of the telescopic tube .
Attach the floor inlet nozzle to the telescopic tube:
Make sure the floor nozzle is attached the narrower part of the telescopic tube .
Adjust the length of the telescopic tube:
Adjust the length of the telescopic tube as follows: Move and hold the button on the tube forward as shown by
the arrows and adjust the length of the tube as required . Release the button and move the tube slightly forward
until you hear a „click" . The telescopic tube is now securely fixed in position .
USING YOUR VACUUM CLEANER
Connecting your vacuum cleaner to the electrical power grid
Pull the plug attached to the power cord out from the vacuum cleaner until the desired length of the cord is out
of the product . Insert the plug into the socket .
Caution:
Yellow marking on the power cord warns that the power cord is close to its end . Do not pull the cord
further than the red marking .
Adjusting the floor inlet nozzle according to the floor surface
You may set the inlet nozzle according to the floor surface by adjusting the inlet flap:
•
If you want to vacuum carpets, close the bristles of the inlet inside the inlet nozzle, by turning the flap
accordingly .
•
If you want to vacuum hard and smooth surfaces, move the bristles out of the nozzle, by turning the flap
accordingly .
