Vacuum cleaner
SVC 7CA-NAA1-09 / SVC 7CA-NAA1-10 /SVC 7CA-NAA1-11 / SVC 7XX-NAA1-YY
EN
EN-5
Copyright © 2014, Fast ČR, a.s.
Revision 10/2014
C
1
Carrying handle
2
Front wheel mechanism
3
Stabilizing travel wheel
4
Vertical parking position
5
Stabilizing travel wheel
1
2
3
4
5
ASSEMBLY
Inserting the hose into the air suction hole on the vacuum cleaner:
Press both the safety buttons on the end of the hose end and insert the hose end into the air suction opening on
the vacuum cleaner until you hear a "click". The hose is now secured in the correct position.
Attach the holder to the telescopic tube:
Make sure to place the holder with the hose on the wider part of the telescopic tube.
Attach the fl oor inlet nozzle to the telescopic tube:
Make sure the fl oor nozzle is attached to the narrower part of the telescopic tube.
Adjust the length of the telescopic tube:
Adjust the length of the telescopic tube as follows: Move and hold the button on the tube forward as shown by
the arrows and adjust the length of the tube as required. Release the button and move the tube slightly forward
until you hear a "click". The telescopic tube is now securely fi xed in position.
USING YOUR VACUUM CLEANER
Connecting your vacuum cleaner to the electrical power grid
Pull the plug attached to the power cord out from the vacuum cleaner until the desired length of the cord is out
of the product. Insert the plug into the socket.
Caution:
The yellow marking on the power cord warns that the power cord is close to its end. Never pull the cord
farther out than the red marking.
Adjusting the fl oor inlet nozzle according to the fl oor surface
You may set the inlet nozzle according to the fl oor surface by adjusting the inlet fl ap:
•
If you want to vacuum carpets, close the bristles of the inlet inside the inlet nozzle, by turning the fl ap
accordingly.
•
If you want to vacuum hard and smooth surfaces, move the bristles out of the nozzle, by turning the fl ap
accordingly.
