Sencor SPV-6712, Руководство пользователя

Страница: 5 / 116

English
4
Using the Remote Control
Point the remote control at the remote control sensor.
•
The remote will function to approximately 6 metres from the remote sensor at an angle of approximately
•
30 each direction.
Directing the remote sensor toward any light source, such as direct sunlight, may cause the unit to
•
malfunction.
Do not spill water or put wet items on the remote control.
•
Never disassemble remote control.
•
Changing batteries in the remote control
1
2
C R 2025
To power of remote control is used Lithium battery CR2025.
To change the battery follow the instruction:
1. Press holder battery lock to the left and pull out holder from
the remote control.
2. Take out an empty battery from the holder.
3. Place a new battery, make sure (on battery) is
facing upwards. Then push back the holder with battery.
Caution:
‹
Incorrect use of batteries may cause them to leak, corrode or explode.
‹
Be sure to place the batteries in the correct direction.
‹
It is dangerous to charge/heat/open or short-circuit the batteries.
‹
Do not leave dead or expired batteries or mix old/new batteries.
‹
When not using the remote control for a long duration of time, remove the batteries.
‹
When operating range becomes reduced, replace all batteries with new, fresh ones.
‹
If leakage from the battery occurs, wipe the battery liquid from the battery
Built-in Rechargeable Battery Management
The capacity of built-in rechargeable Lithium Polymere battery is 1300mAh, which can provide about 1.5
hours of operation.
This portable TV used a smart battery management system inside which can support low battery detection.
1. If the battery voltage falls below a specifi c value, the unit will enter low battery mode, displaying a
fl ashing low battery icon in the OSD, indicating the user needs to recharge the TV immediately.
2. If the AC/DC adapter is connected, it will supply the unit with power, and the battery will be charged
automatically, whatever the power switch is ON or OFF.
3. If the user keep on watching without connect with the fi tted DC adaptor, after the battery exhausted, an
empty battery icon will display and blink at the left up corner, the TFT screen will turn into black instead
of display the picture and the audio will be muted. But the system are still working, if the user plug the
DC adaptor at this time in time, the system will back to normal working mode, the video and audio will
reproduce again.