EN-6
EN
Make-up Mirror
SMM 2030SS
2015
12/2015
BASIC FUNCTIONS OF THE MAKE-UP MIRROR
Possible uses
-
the make-up mirror can be mounted on a mirror using suction cups (included)
-
the make-up mirror can be mounted on a wall using screws (screw are not included)
-
the make-up mirror can be held by hand or taken along in a handbag
Setting the mirror to the desired position
The mirror holder is designed to enable it to be tilted up, down and to the sides. At the same time, it is
possible to simply take the mirror off the holder.
LED mirror light
The mirror light can be turned on using button A
5
. Button A
5
is located on the rear side of the mirror
unit.
To light the make-up mirror a LED light source was used. The LED light source is characterised
by low power consumption and a long lifetime.
USING THE MAKE-UP MIRROR
1) Take the mirror out of the packaging material.
2) Prior to first turning on the mirror, it is necessary to insert the batteries (see paragraph INSTALLING
/ REPLACING BATTERIES).
3) Fit the included suction cups into the mirror holder. Lightly dampen the suction cups with water.
4) Mount the mirror holder on a smooth, clean and degreased surface.
5) Place the rear side of the mirror against the holder. The built-in magnet will ensure firm attachment
of the mirror to the holder whilst allowing the mirror to be tilted in a significant range.
6) To turn on the mirror light, press button A
5
.
7) To turn off the mirror light, press button A
5
.
INSTALLING AND REPLACING BATTERIES
1) When the mirror is attached to the holder, hold down the holder with one hand and use the other
hand to carefully take the mirror off.
2) Remove the rear metal cover on the mirror (see B
1
)
3) Insert three 1.5 V type-AAA batteries into the mirror. Make sure that the batteries are inserted
according to the markings.
4) Close the mirror by putting on the rear metal cover (see figure B
2
). When closing the mirror unit,
pay attention to the triangular mark on the frame of the mirror. The mark must fit into the cut-out
in the metal cover.
MAINTENANCE AND CLEANING
Before cleaning, take the mirror off the holder and turn off the mirror light. To clean the mirror use
a dry, soft cloth. In the case of heavy soiling, wipe the mirror with a damp cloth and then polish using
a dry cloth.
The rear metal cover can be removed from the mirror (see figure B
1
) and cleaned separately.
Do not use chemical or abrasive cleaning agents. The surface could be damaged.
