•
Procedure to Pair #1 and #4 Helmets
•
On the #1 helmet, hold down the Center Button for 5 seconds until you hear the voice prompt
say
“Intercom Pairing”
to place the Tufftalk Lite into Intercom Pairing Mode.
•
On the #4 helmet, hold down the Center Button for 5 seconds until you hear the voice prompt
say
“Intercom Pairing”
to place the Tufftalk Lite into Intercom Pairing Mode.
•
When both helmets are Intercom Pairing Mode and the LEDs are flashing red rapidly, tap the
Center Button once on either of the headset/helmets.
•
The LEDs will change to flashing blue slowly on both helmets at the same time.
•
Tap the Center Button once on either of the headset/helmets to disconnect the intercom.
•
Procedure to connect all helmets
•
Once Headsets on helmets are initially paired there is no need to re-pair them after headsets are
powered off. Pairing is stored in Memory on each headset. Power on all four headsets: Hold
down the Center Button and the Plus (+) Button at the same time until the blue LED appears.
You’ll hear a voice prompt say
“Hello”
. The red LED will flash a certain number of times to
indicate the battery level.
•
Tap the (+) Button and the (-) Button on Tufftalk Lite Head Set/Helmet #1 at the same time to
activate Group Intercom and connect all 4 headsets together for a Four-Way Intercom
conference. (It is advised to use a sharpie marker to designate helmet/headset #1)
If #1 headset/helmet disconnects the whole group disconnects.
Once paired together, #1 helmet can connect or disconnect the intercom with a specific helmet by
tapping the Center Button a specific number of times for a 1-to-1 conversation.
#4 helmet = 1 tap
#3 helmet = 2 taps
#2 helmet = 3 taps
#4 helmet, #3 helmet or #2 helmet can connect to #1 helmet by tapping the Center Button once for a 1-
to-1 conversation.
