DirectPort-USB
Page 27 of 36
2.
This page allows configuration of the basic device parameters (i.e. Baud rate, data bits, parity, stop bits
and flow control).
To access more advanced settings, click on the "Advanced… " button to display the
advanced properties page (shown below).
3.
This page will allow the following parameters to be altered:
COM port number
USB buffer sizes
Latency timer
Alter this to correct compatibility problems for obsolete applications.
Read and write timeout values
You can alter this for timing of timeout event if there are no more Tx/Rx data.
Miscellaneous options
Serial Emulator : The function of the serial enumerator is to detect a Plug-and-Play enabled
device (such as a serial mouse or serial modem) that is attached to the USB serial port.
Serial Printer : If enabled, serial printer will disable timeouts to allow for long delays associated
with paper loading.
Cancel If Power Off : The Cancel If Power Off
option can be used to assist with problems
encountered when going into a hibernate or suspend condition.
This will cancel any requests
received by the driver when going into hibernate or suspend.
Event on Surprise Removal : The Event On Surprise Removal option is generally left
unselected.
If an application sets SERIAL_EV_EVENT2 (refer Windows DDK) in it's event
bitmask and this feature is enabled, the device driver will signal this event on surprise removal.
Set RTS on Close : Selecting the Set RTS On Close option will set the RTS signal on closing
the port.
Disable Modem Control at Startup : This option is used to control the modem control signals
DTR and RTS at startup.
In normal operation, the modem control signals at startup follow the
behavior of the legacy port.
However, due to timing differences between a legacy COM port
and a virtual COM port, a "spike" on one of these signals in the legacy port can appear as an
assertion of the signal in the virtual COM port.
Devices that monitor these signals can enter the wrong state after an unplug-replug cycle on
USB. Note that if the "Serial Enumerator" option in the property page is selected, then the
