Semtech TS8000 Flash Series, Руководство по программированию

Страница: 14 / 17

TS8000x Programming Guide
www.semtech.com
13 of 16
Rev 0.9 Sep 2016 Semtech
Checklist 1: Semtech USB-I2C Adapter & Wireless Power
GUI
Software Installation
1. At www.semtech.com , keyword search for
TS80000.
Under
Docs & Resources,
click
TS8000X
GUI
to download
SemtechWirelessPowerGUI_setup.zip
to your PC.
2. Under the
Tools and Firmware
tab, download image file
160815a_TX_LOW_POWER_TS51223_enc.
3. Extract
setup.exe
and
WirelessPowerGUI_setup.msi
from the zip archive.
4. Run
setup.exe
and follow the prompts to install the Semtech Wireless Power GUI software.
Hardware Preparation
1. Obtain a Semtech USB to I2C adapter board from a
TSWITX-EVM
EVM kits can be found at:
http://semtech.com/wireless-charging.
2. Connect I2C serial clock, data, and ground from the adapter board to the target board as shown
below.
Note that Vcc should not be connected if target board is independently powered.
3. To invoke bootloader mode, tie DEBUG to ground on the target board.
4. Powerup the target and plug the adapter board into the USB port on the programming PC.
Programming Sequence
1. Launch the GUI by clicking on the
Semtech Wireless Power GUI
icon:
2. On the
Device
tab, select the TS8000x version that matches your
device.
3. Verify the Status indicates the selected TS8000x is
Connected.
4. Click on the
Firmware
tab.
5. Locate the firmware BIN file to be installed via the
…
button.
6. Click
Program
to begin the download.
7. Note the green progress bar and verify the download succeeded.
8. Close the GUI, power down the boards and remove the cables.