Program the trans mi t
20
5.
Program the transmit
…into a receiver or a drive
The simple assignment between transmitter and receiver is
described below. The description of the assignment of special
transmitters and / or multiple receivers, as well as the reset
and manufacture of the factory setting, is described in the
operating instructions of the respective products.
PROG button / SELECT button: Only operate with an insulated
tool (at least 1 kV voltage).
The end limits must already be set correctly.
step 1:
Disconnect the mains voltage of the receiver or actuator
for at least 1 second and then switch it on again.
The receiver / drive can be found in the next 4
minutes from the
commeo Transmit
step 2:
Switch on SELECT mode: Press SELECT button for 3
seconds.
The
commeo Transmit
"searches" the previously
activated receiver or drive
The assignment is indicated by a short jogging of the
system
All manuals and user guides at all-guides.com
