SmartBox
®
MINI
Artikel-Nr.
308 051
INSTALLING THE SMARTBOX MINI
Before installation, check that the product is complete and has not suffered any damage
during transport.
ASSEMBLY, START-UP and MAINTENANCE are to be carried out by a specialised
company in terms of water law.
For the system to function as intended it must be installed professionally in compliance with
the technical instructions applicable to the planning, construction and operation of the entire
system.
These regulations also include the accident prevention regulations of the employers’ liability
insurance associations, the VDE regulations, and the installation and operating instructions.
Installation instructions
The display unit has a wall installation housing and is operated with the top of the housing
closed. Installation and start-up by a specialised installer is carried out with the display unit
open.
Installation of the digital display unit
1. Loosen the screw on the bottom of the digital display unit and remove the top of the
housing.
2. Place the digital display unit on a suitable position on a smooth, vertical wall and pierce
the pre-cut holes on the inside back wall of the housing. Mark the points for installation.
NOTICE
Do not damage electronic components.
Use a suitable tool to pierce the openings.
3. Place the digital display unit on the marks and fix it in place using the supplied anchors
and
screws.
4. Close the top of the housing and tighten the screw on the bottom of the digital display unit.
TROUBLESHOOTING
Fault cause
Action
Battery warning Battery _ _%
when remaining capacity is low
«
Constant check
No display
Batteries empty
«
Replace batteries
Error code
Meaning
Error 0001
No contact with FSA-E
Check the connection between the magnetic sensor
and the magnetic encoder in the connection plug on
the FSA-E
Error 0002
Connection cable on the digital display unit not connected
Connect the cable
22/72
