Getting Started Quickly
Where batteries are joined
in
parallel
, add the capacities
together, the voltage will
remain the same as each
batteries voltage.
2 x 12 Volt 150 Ah batteries connected in parallel would have a
capacity of 12 Volts – 300 Ah.
Only use identical batteries when joining batteries together.
How long will my battery last
To work out how long your battery will last follow this basic guide.
This guide presumes commencing with a fully charged battery.
Take the total rating of the appliance being run
1
light globe
25watts
1
20 inch TV
67watts
1 VCR
30watts
Total load
=122watts
Divide this figure (122) by 10 to know the approximate DC current draw
=12.2Amps
To convert this to Ampere hours, multiply by the number of hours used -
Say 1 hour
=12.2Ah
So if we have a 150Ah battery, then with the above example we should have
150 minus 12.2 = 137.8 Ah remaining in the battery.
As a general guide never discharge a battery below 50%. The deeper
a battery is discharged on a regular basis, the less life you can expect
from the battery. The Ah rating of a battery will also be reduced if
the drain current is greater than the rated discharge current. See your
battery specifications for full details.
If you want to get powered up quickly here are the 11 simple steps.
1.
Familiarise yourself with the details in the first 6 pages on this manual.
2.
Unpack the LD350-12 from the packaging.
3.
Check unit for any damage that may have resulted during transport, if any
damage is evident report this to your supplier immediately.
4.
Make sure the LD350-12 ON/OFF switch (12) is in the off position.
5.
Connect battery positive wire (red) (10) to battery positive or battery fuse.
6.
Connect battery neg. wire (black) (11) to battery negative or battery fuse.
7.
Plug a 230 - 240V appliance into inverter front power point (8) but do not
switch on.
8.
Turn ON/OFF switch (12) to ON.
9.
After 3 seconds LED (1) will begin to flash. If no LEDs light, check for
correct connection to battery.
10.
Turn power point (8) on
11.
You’re away.
LD350-12 Parts Identification
LED (1)
LED (2)
LED (3)
LED (4)
ON/OFF Switch (12)
LED (5)
Mode Button (7)
(8) Power Point/GPO
Positive (Red) Battery lead (6) can be viewed from the rear.
Negative (Black) Battery Lead (7) can be viewed from the rear.
LD350-12 Manual
Selectronic Australia
5
LD350-12 Manual
Selectronic Australia
6
