INSTALLATION GUIDE | ROMAN SHADES
UPDATED
DEC
2021
4
®
Simple. Smart. Custom.
PAIRING THE REMOTE WITH A MOTOR
NOTE:
The factory pairs each of your shades to the remote. The following steps are only necessary if you want to change how the channels are
configured, or if you are adding a new shade to a remote already in use.
1.
Disconnect the motor cable from the battery.
2.
Set the remote to whichever channel you want to
program the shade to.
3.
Both parts of this step must be completed
within
three seconds.
If you don’t succeed, repeat this
step a bit faster, or have someone assist you.
A.
Plug the motor cable back into the battery.
B.
With your finger, quickly press and hold the
Confirm
(C)
button on the back of the remote.
STEP 1
STEP 3A
STEP 3B
CONFIRM (C)
When the shade jogs (a quick up and down movement), the remote is paired to the channel you’ve chosen.
ADJUSTING UPPER AND LOWER LIMITS
NOTE:
The upper and lower limits are already set-up at the factory, so the following steps
are only necessary if you want to change how these settings are configured. Both limits
must be reprogrammed in these instructions.
1.
Start with the shade fully raised. For a few seconds, press and hold the
Limit
button
until the shade jogs. Your motor is now in programming mode.
2.
Press
Down
to lower the shade until it’s almost to the bottom, then press
Stop
. From
here, repeatedly press
Down
to lower the shade slowly.
3.
When the shade reaches the desired bottom position, flip the remote and use your pen
to press the
Confirm
button. The shade will jog to acknowledge that your lower limit is now
set, but the motor is still in programming mode.
4.
Press
Up
to raise the shade until it’s almost to the top, then press
Stop
. From here,
repeatedly press
Up
to raise the shade slowly.
5.
When the shade reaches the desired top position, flip the remote and use your pen to
press the
Confirm
button. The shade will jog to acknowledge that your upper limit is now
set, and the motor will automatically exit programming mode.
SETTING A FAVORITE POSITION (OPTIONAL)
1.
Start with the shade raised fully, then press the
Down
button for the shade to lower.
2.
Press
Stop
at the position you wish to save as your favorite.
3.
Simultaneously press and hold the
Limit
button and the
Up
button, until the shade
jogs. Your favorite position is now set. If you wish to change the favorite position,
simply repeat these steps again.
LIMIT (L)
DELETING A CHANNEL FROM THE MOTOR
NOTE:
Removing a remote or channel from a shade does not delete or reset the limit settings.
1.
Select the channel you’d like to disconnect the shade from.
2.
Press the
Confirm
button repeatedly (about 3 - 7 presses); the shade will jog three individual times. After the
third jog, your channel is removed from the shade, and ready to be assigned to a new channel or a new remote.
CONFIRM (C)
CONFIRM
(C)
CONFIRM
(C)
LIMIT (L)
