TOOLS REQUIRED
INSTALLATION GUIDE | ROMAN SHADES
UPDATED
DEC
2021
5
®
Simple. Smart. Custom.
®
Simple. Smart. Custom.
INSTALLATION GUIDE
ROMAN SHADES
LIFT SYSTEMS:
CORDED LIFT | CORDLESS LIFT
1
2
3
The difficulty level of this installation is ranked at Level 1.
A piece of cake!
HARDWARE AND PARTS INCLUDED
*Recommended if mounting into hollow drywall.
CORDLESS HANDLE
CORD CLEAT AND SCREW
BRACKET WITH WINGNUT
SCREWS
WALL ANCHORS*
PENCIL
POWER DRILL
LEVEL
TAPE MEASURE
STEP LADDER
1.
Grasp the shade by the headrail and hold it up inside the top of the window. Set it back until
the front of the shade is flush with the wall. Hold the shade in place, and with a pencil, make a
mark through each hole in the headrail. Set the shade aside.
2.
Take a bracket and center the drop-bolt over each mark. Use the holes in the top of the
bracket to mark where your two screws will go.
3.
Align the brackets with the holes, and use a Phillips drill bit to securely fasten the screws.
NOTE:
Corded and cordless shades have pre-drilled holes in the top of the headrail.
You will use these holes as a guide for your bracket placement. If using your own
screws instead of those provided, be sure to pre-drill a small hole with a 5/64” drill
bit before the final screws go in to attach brackets.
MOUNTING THE BRACKETS
1.
PRE-DRILLED HOLES
FRONT
BACK
DROP-BOLT
INSIDE MOUNT
1.
Center and hold the headrail at least two inches above the window. While
keeping the shade level, make a small line with your pencil just above each of
the pre-drilled holes in the headrail. Set the shade aside.
2.
Align the top edge of a bracket along each mark, and use the holes in the
back of the bracket to mark where your two screws will go.
3.
Align the brackets with the holes, and use a Phillips drill bit to fasten the
screws in place.
*If you are using wall anchors, pre-drill with a 1/4” bit instead, and tap the wall
anchors into the holes with a hammer before drilling in the screws.
NOTE:
If using your own screws instead of those provided, be sure to pre-drill a
small hole with a 5/64” drill bit before the final screws go in to attach brackets.
OUTSIDE MOUNT
PHILLIPS SCREWDRIVER
PHILLIPS DRILL BIT
5/64” DRILL BIT
If you have questions or get stuck, call our Customer Care Team at
888-685-1735, or email [email protected]
