Sekonic Litemaster Pro L-478DR, Руководство по эксплуатации

Страница: 8 / 16

8
2-2. Measuring in Radio Flash Mode
2-2-1. How to use Radio Triggering
1) Touch the Measuring Mode icon ( ) at the top left of the Measuring screen and then
select the Radio Flash Mode ( ).
Measuring screen Measuring Mode Selection screen Measuring screen
2) Set ISO sensitivity on the ISO icon.
3) Set shutter speed on the T (shutter speed) icon.
4) Make sure that the channel and Zones are the
same for the meter and receivers in use.
* Select the Zone to trigger from the Flash Power Control
screen (See below) or Tool Box.
5) Press the Measuring button to trigger the flash
units. The measured value (f-stop) is displayed.
•
When firing the flash, if the flash brightness is 8EV lower than the
ambient light, the meter may fail to detect the flash light. In this
case, make measurements using the Cord (PC) Flash Mode (See
L-478 Series Common Operating Manual for details).
•
Rapid start fluorescent lamps and special lighting are sometimes
mistaken for flash, and accidentally measured. In this case, make
measurements using the Cord (PC) Flash Mode (See L-478 Series
Common Operating Manual for details).
•
The waveform of a flash bulb has a slight slope and there is a
possibility that the light meter cannot recognize the flashbulb in
Cordless Flash Mode. In this case, make measurements using the
Cord (PC) Flash Mode (See L-478 Series Common Operating
Manual for details).
Measuring screen
(After Measurement)
Measuring screen
Set channel
number and
Zones
Go to Power
Control
screen
Tool Box