6. Product conformity information
6.1 Simplified EU declaration of conformity
Hereby,
SI-TEX Marine Electronics, 25 Enterprise Zone Drive suite 2, Riverhead, NY 11901, USA declares
that the radio equipments in the following table are in compliance with Directive 2014/53/EU.
Si-Tex 4kW Radar Antenna
MDS-12
The full text of the EU declaration of conformity for every single product is available at the following
internet address:
eudeclaration.avmap.it
5.1 Setup configuration
1.
Connect your WiFi router to a PC using the WiFi router program and pre-configure the WiFi
router settings as following:
- Set the WiFi router IP Address to 223.168.1.1
- Set WiFi Router USERNAME and PASSWORD as per your preference.
In this setup configuration as example we set USERNAME to “Radar MDS-12” and
PASSWORD to ”12345678”.
- Save the settings of your WiFi router and disconnect the WiFi router from the PC.
2.
Connect the MDS-12 ethernet cable to the pre-configured WiFi router as shown on figure 5.1
3.
Connect the radar MDS-12 to correct power source as shown on figure 5.1.
4.
Power on the radar MDS-12.
5.
Power on the Seiwa WiFi navigation system.
6.
In the main menu of the Seiwa WiFi navigation system open the “Ports and Connectivity” menu,
select WiFi and enable Wireless LAN. After that you can select the WiFi router USERNAME
from the list of available networks. As per our example Radar MDS-12 appears on the list and
use the WiFi router PASSWORD to connect. As per our example PASSWORD “12345678”.
Note
: The network will be remembered by the Seiwa WiFi navigation system and next time it will be
connected automatically.
WiFi Router
Seiwa WiFi Navigation System
Ethernet Cable
Figure 5.1
Radar Antenna MDS-12 cable
Cable color
Function
Black
PWR -
Red
PWR + (10.5 to 40 Vdc)
Black
with ring connector
GND
Note:
the ground wire (black cable with ring connector) is used to connect to the grounding of the
metal boat. For wooden or fibreglass boats it is not needed to connect the ground wire.
Note:
it is suggested to add a power switch with fuse (5A for 12V and 3A for 24V) for the radar antenna.
