RA-‐OM-‐713
3
Your
SEISCO
®
is designed for easy maintenance.
AVOID INSTALLATION
IN CONFINED SPACES.
Allow at least 18 inches of working space above
and below your unit. Installing any water heater
in your attic or any
other location that is not easily monitored can result in unexpected
property damage. Your
SEISCO
®
is so small and attractive, you should
NEVER need to install it in attics or areas difficult to monitor or service.
WHEN INSTALLING THE SEISCO IN ANY AREA WHERE LEAKS OF ANY
NATURE COULD CAUSE PROPERTY DAMAGE OR ANY OTHER AREAS
THAT ARE NOT READILY VISIBLE OR ROUTINELY MONITORED
INCLUDING CLOSETS, CABINETS, ATTICS: A 150-‐PSI MAXIMUM
PRESSURE RELIEF VALVE WITH DRAIN LINE
AND
A DRAIN PAN AND
DRAIN LINE SUFFICIENT FOR CONTAINING THE FLOW OF WATER
PROVIDED BY THE SUPPLY LINE
MUST
BE INSTALLED.
WHEN LEAVING YOUR HOME FOR MORE THAN TWO DAYS, TURN
OFF THE SUPPLY WATER OR ALTERNATIVELY THE POWER TO THE
HEATER.
Your
SEISCO
®
should require very little maintenance. In areas of hard
water, it is advisable annually, to remove its detachable base plates and
clean out any mineral deposits from the chambers.
NEVER POUR OR SPRAY LIQUIDS DIRECTLY ON THE UNIT THAT
MIGHT ENTER THE CASE, POSSIBLY CAUSING DAMAGE TO YOUR
UNIT.
Your
SEISCO
®
is designed for safe operation and ease of service.
Qualified service personnel must service your unit only.
BEFORE YOUR
UNIT IS TO BE SERVICED, ALWAYS TURN OFF ALL MAIN, POWER
CIRCUIT BREAKERS TO THE UNIT.
After servicing, always
RUN
WATER
through your unit before turning the power on.
YOUR SEISCO
®
MUST BE INSTALLED AND SERVICED BY QUALIFIED
PERSONNEL. DAMAGE TO YOUR UNIT, SERIOUS PERSONAL INJURY
OR DEATH MAY OCCUR IF INSTALLED OR HANDLED IMPROPERLY.
CARE MUST ALWAYS BE USED TO AVOID ELECTRICAL ACCIDENTS
WHEN INSTALLING OR SERVICING. NEVER USE PARTS THAT ARE
NOT ORIGINAL EQUIPMENT OR APPROVED ALTERNATE
REPLACEMENT PARTS.
Protect your
SEISCO
®
from the weather. It is an appliance, and you must
avoid installing this
SEISCO
®
in unprotected areas where it might be
exposed to rain, excess humidity, freezing conditions, etc.
Your
SEISCO
®
is designed to operate ONLY when mounted vertically. Do
not attempt to mount any other way as permanent damage to your unit
will result with possible catastrophic failure and significant water
leakage.
DOs & DON’Ts
