Seiko Seiki STPH1303C, Инструкция по эксплуатации

Страница: 35 / 125

STP-H803/H1303 Series Instruction Manual
1) When securing the inlet port with bolts 1) When securing the inlet port with bolts
Refer to Table 4.2 for torque in pump abnormality and recommended
securing bolts. Secure the inlet port flange with all of the boltholes of
the size specified in the Inlet Port Flange Standard Reduced diameter
shank bolts (R.D.S.B.) listed on Table 4.2 are more reinforced bolts over
standard bolts by smoothing the portion to attach flange securing bolts to
the respective face at the equipment side. Refer to Figure 4.6 for Shape
of R.D.S.B. Secure the base with all 8 screw-holes for legs or all 8
attached legs. Follow "CAUTION" on page 4-9 about legs and bolts for
securing the base. Make sure that the recommended securing bolt may
be different depending on the method of securing the base.
In
sta
lla
tio
n
sta
lla
tio
n
Table 4.2 Maximum Torque predicted and Recommended securing bolt for inlet port flange
Model of TMP STP-H803
Type of flange VG150 ISO160F ICF203
Torque in pump
abnormality [Nm]
2.8×10
4
2.8×10
4
2.8×10
4
Base(8 positions)securing No Yes No Yes No Yes
Type of bolt R.D.S.B.
*2
Standard R.D.S.B.
*2
Standard Standard Standard
Type of steel *1
Carbon steel
Alloyed steel Stainless steel
Carbon steel
Alloyed steel Stainless steel
Carbon steel
Alloyed steel Stainless steel
Recommended
securing bolt
for TMP Flange
Strength *1 12.9 or more 70 or more
Equivalent to
AMS 6419
70 or more 12.9 or more 70 or more
Model of TMP STP-H1303
Type of flange VG200 ISO200F/ISO200 ICF253/ICF305
Torque in pump
abnormality [Nm]
2.8×10
4
2.3×10
4
2.8×10
4
Base(8 positions)securing No Yes No Yes No Yes
Type of bolt Standard Standard Standard Standard Standard Standard
Type of steel *1 Stainless steel Stainless steel Stainless steel Stainless steel Stainless steel Stainless steel
Recommended
securing bolt
for TMP Flange
Strength
*1
70 or more 70 or more 70 or more 70 or more 70 or more 70 or more
Secure the base
Recommended fitting
bolt for flange
(b) When the base is secured (a) When the base is not secured
Figure 4.5 Example of securing the STP pump
(When securing the inlet port with bolts)
4-10
*1
Refer to ISO898-1(JISB1051), ISO3506(JISB1054) and AMS6419(Aerospace Material Specification)
*2
Refer to Shape of Reduced Diameter Shank Bolts(=R.D.S.B.) Figure 4.6