background image

5

IN CASE OF AN UNUSUAL MOVEMENT OF THE SECOND HAND

 50 

English

6

TROUBLESHOOTING

 51 

English

Power…Save…1

Power…Save…2

State

The…second…hand…stops…

pointing…at…the…15-sec…

position.

The…second…hand…stops…pointing…at…

the…45-sec…position.

Restriction…

on…function/

display

・…The…hour…hand,…minute…hand,…date,…and…

sub-dial…stop.

・…Automatic…time…adjustment…is…not…

performed.

・…The…hour…hand,…minute…hand,…date,…and…sub-dial…stop.(Date…displays…“1.”)

・…Reception…is…not…started…even…with…operation…of…GPS…

signal…reception.

・Automatic…time…adjustment…is…not…performed.

・The…indicator…hand…points…to…“E.”

Cause

When…the…watch…is…exposed…to…a…state…without…receiving…

an…adequate…light…source…for…72…hours…or…longer.

When…the…watch…is…in…an…insufficient…charging…state…for…a…

long…time.

Solution

When…the…watch…is…exposed…to…an…adequate…light…

source…for…more…than…5…seconds,…or…when…any…

button…is…pressed,…it…displays…the…current…time…

again…after…the…second…hand…is…rapidly…advanced.

① …Charge…the…watch…sufficiently…until…the…charging…status…is…

displayed…as…the…“level…position…(middle)”…or…“F…(full).”…

②…Carry…out…time…zone…adjustment…to…set…the…time.

Power…Save…2
※… …While…the…watch…is…being…charged,…the…second…hand…moves…at…“…5-sec…Intervals.”……During…the…“5-sec…Interval…Movement,”…neither…the…

buttons…nor…the…crown…can…be…operated.

※… If…the…“…Power…Save…2”…mode…is…prolonged,…the…stored…power…amount…drops…and…the…internal…current…time…information…stored…will…be…lost.

 Power save function (The second hand stops at the 15-sec position/45-sec position)

When the watch is not exposed to light for a long time, the power save function will work.

 The second hand stops at the 0-sec or 5-sec 
position (automatic time adjustment)

Automatic time adjustment is being performed.

The indicator hand points to “1.”

It…takes…up…to…1…min…to…
complete…reception.

 The second hand is stopped between the 0-sec to 18-sec 
positions (Ready for leap second data reception)

The watch is ready for leap second data reception. The second hand indicates the waiting time 

until the leap second data reception by minutes.

→ Automatic leap second reception function 

P.48

● The second hand stops at the 45-sec position before the 

reception is completed (The watch enters the power save 2 

state)

 ・ If   G P S   s i g n a l   r e c e p t i o n   i s   p e r f o r m e d   u n d e r   l o w 

temperatures (0°C or less) in a state where the charging 

capacity and/or charging efficiency are lowered, the reception will be stopped, and the watch may enter 

the power save 2 state.

     If this occurs frequently, consult the retailer from whom the watch was purchased.

   GPS  signal  reception  consumes  a  significant  amount  of  energy.  Keep  in  mind  to  charge  the  watch 

regularly by expose to light.

・…When…using…the…watch…again…under…a…condition…in…which…the…watch…is…able…to…receive…radio…signals,…receive…

radio…signals…to…set…the…time.

・When…adjusting…the…time,…the…date…will…be…accordingly…adjusted.

● Reception is not started even with operation of GPS 

signal reception (time zone adjustment/manual time 

adjustment).

 ・Check the indicator hand position. 

● Reception is not possible even with operation of GPS signal 

reception (time zone adjustment/manual time adjustment) 

(The reception result is displayed as “N.”)

 ・ove to a place where GPS signals can be easily received.  

When the watch is unable to receive GPS signals

Manual time/date setting (Adjust the time under a condition in which the watch is unable to receive GPS signals)

Points to be checked

When the watch does not start receiving or is unable to receive GPS signals even with operation 

of GPS signal reception, the following can be considered.

Manual time/date setting

When a problem cannot be solved even by carrying out the “

 

Points to be checked,” or time is 

gained or lost under a condition in which the watch is unable to receive GPS signals and the watch 

is unable to receive GPS signals continuously, set the time and date manually.

Reception…

is…not…

allowed

Indicator…

display

Charging…status

In-flight…mode( )

E…(low)

Display

Solution

Charge…the…watch…by…

expose…to…light…until…the…

indicator…hand…points…

to…the…“level…position…

(middle)”…or…“F…(full).”…

Reset…the…in-

flight…mode( )

→…

P.42

Continued on the following page

Содержание CSB7X52

















Отзывы: