Seiki SC-45AU6DR, Инструкция по эксплуатации, Страница: 11 / 20

11
Do not fix brackets to
plasterboard directly
Ensure brackets are
securely fastened. Fit
timber slats if necessary.
**Wall mounting continues on next page.
GETTING STARTED (Cont.)
WALL MOUNTING INSTRUCTIONS
• Ensure that the wall can adequately support the weight of the dryer.
• Ensure all fasteners used for wall mounted are of the correct type and can
support the weight of the dryer and load.
• If wall mounting above a washing machine make sure there is enough room for
the lid to open.
• Allows 5-10cm ontop of the dryer for ease of installation if you are installing the
appliance near the ceiling.
• If wall mounting dryer onto a plasterboard wall, make sure the brackets are
securely fitted to a timer stud, if the space between the studs is too wide,
fit a timber slat between the studs. (if using a timber slat, ensure you fit a
secondary slat at the bottom to align bottom spaces of the wall).
• If mounting to a masonry wall, use the correct anchoring bolts of a least a
minimum size of 8 x 40 mm.
The below instruction will guide you on the measurements needed to drill the
holes, the positioning of the hooks and support parts.
1. Determine dryer position on the wall and mark required bracket position. The
distance to mark between each bracket hole is 554 mm. (refer to figure 1)
2. Fix the wall hanging brackets (2 supplied) to the wall securely (into the stud/
timber slat). Fit a timber slat between the studs to mount the brackets onto the
stud if position is too wide.
12G x 8
Distance between
mounting holes
Fig. 1
Bottom Slat
Timber Slat