Power/Mute Switch
3
3
BELTPACK MIC
Antenna
1
1
2
2
Status Indicator
This permanently attached transmitter antenna should be fully extended during normal
operation.
This LED displays the operation mode:
GREEN
RED
Flashing RED
Normal Operation
Mute
Low Battery
CONTROL ELEMENTS
7
Battery Holder
4
4
Open the battery holder by pressing the tab and lifting the cover.insert two standard AA(LR6)
batteries here,being sure to observe the plus and minus polarity markings shown.Although
rechargeable Ni-Cad batteries can be used,they do not supply adequate current for more
than four hours.WARNING:Do not insert the batteries backwards;doing so can cause severe
damage to the MIC and will void your warranty.
Input GAIN Control
5
5
This control adjusts the transmitter input sensitivity.For optimal performance, using the included
screwdriver,
IR Lens
6
6
This w
indow i s u sed t o c apture t he i nfrared s ignal s ent f rom t he
d
u ring th e IR U P/DOWN
t o c hannelize t he t ransmitter.The b attery c over m
ust b e o pen a nd t he I R L ens f acing t owards t he
receiver to load the selected channel.
receiver
Plastic Screwdriver
7
7
Designed for use in adjusting the MIC input GAIN control(See #5 Input GAIN Control HH).
Set the input GAIN control to where you can see the RF display of receiver
screen become to fulllight, the n turn do
wn u ntil the RF displ ay n ot full light (les sth anfive).
Input GAIN Control
This control adjusts the transmitter input sensitivity to work with microphone and instruments
inputs.For optimal performance,using the included screwdriver,
6
6
Driver
Designed for use in adjusting the MIC input GAIN control.
7
7
IR Receiving Section
This window is used to capture the infrared signal sent from the receiver during the IR UP/DOWN
to channelize the transmitter.
5
5
4
4
MINI 4P CONNECTOR
CONTROL ELEMENTS
8
Pin 1, GND
Pin 4, for Dynamic or condenser microphone
Pin 2, Phantom power supply for Condenser microphone
Pin 3, for Guitar, bass and keyboards
A
A
B
B
C
C
D
D
B
B
C
C
A
A
D
D
4
4
1
1
3
3
2
2
7
7
6
6
5
5
1
1
Set the input GAIN controlt o
where you can see the RF display of U-299R screen become to full light , th en tu rn dow
n
until the T he refore display not full light(less than five).
Press and hold to turn the unit on or off. Press and release to mute or unmute the transmitter.
receiver
Содержание U-299H
Страница 2: ...User s Manual WIRELESS MICROPHONE SYSTEM NF04117 1 1...
Страница 3: ......
