When choosing a location for your new fireplace, ensure that the general instructions are properly followed.
For best result, install the fireplace out of direct sunlight.
OPERATING INSTRUCTIONS
CONTROL PANEL OPERATING PROCEDURES
NOTE:
1. When you first turn the heater on, it may emit a slight but harmless odor. This odor results from certain oils or greases
being heated as the appliance is used for the first time. This odor is perfectly safe and will stop shortly, it will not
reoccur after the first operation of the appliance.
Control Panel
Using the Control Panel:
Master Power Switch(A)
Open the cover and push button A down (1) to “on” position.(see FIG A)
FLAME EFFECT
Push “O/I” (On/Off) button (B) or “O/I” (On/Off) button (M) on the remote control to begin flame effect. The red power
light “ ” and dimmer light “ ” will automatically come on. The flame effect can be adjusted by pressing the dimmer
“ ” button (C) or dimmer “ ” button (L) on the remote control. When pressed, the red light will blink and the flame
effect will cycle from high to low. Press the dimmer “ “ button (C) or dimmer “ “ button (L) on the remote control
again to lock in desired flame brightness. The red light “ “ will remain on. This brightness will be kept until the dimmer
“ ” button (C) or dimmer “ ” button (L) on the remote control is pressed again.
HEAT SETTING
1. Turning on Master Power Switch (A) and “O/I” (On/Off) button (B) or “O/I” button (M) on the remote control
2. Press “650W” button (D) or “650W” button (K) on the remote control to active the low heater setting. The red
light above will indicate that the heater is functioning on low.
3. Press “650W” button (D) or “650W” button (K) on the remote control again to shut off the heater.
4. Press “1300W” button (E) or “1300W” button (J) on the remote control to active the high heater setting. The red
lights above “650W” and “1300W” buttons will indicate that the heater is functioning on high.
5. Press “1300W” button (E) or “1300W” button (J) on the remote control again to shut off the heater.
Note
When the heater begins to work, it will give off cool air for about 10 seconds before the heating function is activated
