Phillip head screw
Anchor
3.
Measure the wall and mark the
location of the center of each of
the three screw mounting holes.
See Figure 2.
Using the level, make sure that all
three marks are level on the wall.
It’s highly recommended that
middle screw is inserted into a
wall stud.
4. Using the power drill and
3/16
″
drill bit, drill three 3/16”holes
through the wallboard at the
mounting hole marks.
NOTICE
Make sure not to drill into
electrical wiring or plumbing
pipes.
5.
Insert one of the furnished
plastic anchors into each of the
three 3/16
″
holes. See Figure 3.
Make sure that the wall anchor is
flush with the wall.
NOTE
: It may be necessary to
use a small hammer to gently tap
the anchor into place.
6.
Using the phillip head
screwdriver, install one Phillip
Head Screw into each of the
anchors. See Figure 3. Turn the
screw in until there is a gap of
1/4
″
between the head of screw
and the wall surface.
Figure 2 – Screw Hole Location
Figure 3 – Wall Anchor Installation
1
5
-3
/8
"
8"
Drill three 3/16" holes
into wall
1/4" Gap
3/16" Hole
8"
