Segway i2 SE, Руководство по обслуживанию

Страница: 39 / 92

Segway Personal Transporter SE Service Manual 5–3
Fenders
x2 SE Fender
Removal
Tool Required: 4 mm hex wrench
1. Make sure the PT is powered off and unplugged.
2. Remove the Tire/Wheel Assembly (
page 4–3 ).
3. Using a 4 mm hex wrench, remove the four fasteners
holding the Fender to the Fender Frame. See
Figure 5–2 .
4. Remove the Fender from the Fender Frame.
NOTICE
The Fender and Fender Frame can be removed as a
unit by removing the Fender Frame fasteners (see
page 5–4 ).
Installation
Tools Required: 4 mm hex wrench
Torque wrench
1. Make sure the PT is powered off and unplugged.
2. Orient and place the left Fender on the left Fender
Frame. Orient and place the right Fender on the right
Fender Frame.
3. Ensure the grommets are in place on the Fender.
If grommets need to be installed, use a finger to
push the grommets into place. Grommets are
bidirectional and can be installed from either side of
the Fender.
4. Using a 4 mm hex wrench, install the four fasteners
until seated. Tighten one-half to one full turn. See
Figure 5–2 .
5. Install the Tire/Wheel Assembly ( page 4–3 ).
6. Perform post-service tests ( page A–1 ).
Figure 5–2: x2 SE Fender
x2 Fender
20871-00001
½ turn – 1 full turn
after seated