w w w . c l a s s i c
e x h i b i t s . c o m
Step 1
866.652.2100
© 2012
WHEN DISASSEMBLING ALUMINUM EXTRUSION, TIGHTEN ALL
SETSCREWS AND LOCKS TO PREVENT LOSS DURING SHIPPING
Order #XXXXX - VK-1851 - Table Top - Graphic Frame Assembly
Tighten knob
to secure
Corner
Item
1
2
3
4
5
6
Description
44” SEG Extrusion
44” SEG Extrusion
31.5” SEG Extrusion
31.5” SEG Extrusion
31.5” SEG Extrusion
31.5” SEG Extrusion
1
Wing
Wing
2
3
5
4
6
Tighten Knob to secure
Hook keyhole cut
out up bolt
Foot Attachment
Setups:
1) Assembled SEG extrusions together on floor.
2) Apply SEG graphic to assembled frame.
3) Attach feet to both sides of assembled frame
where indicated.
4) Attach wings to assembled frame.
When
assembled
When desired location
is found, tighten
set screw to secure.
Tighten knob to
secure wing in place.
A10 Clamp Attachment
Center
and tighten knob
to secure
Slide connecting
bar between
verticals/horizontals
Graphic Removal
To remove the graphic from
the frame, locate the fabric
pull tab. Gently pull up on the
tab to remove the fabric.
Step 1
Insert corner A. Turn edge of
graphic so silicon welt is
perpendicular to face of
graphic. Insert narrow side
of welt with fabric to outside
into the channel. Repeat for
other side of this corner.
Step 2
Repeat Step 1 for opposite
corner C, then insert corner
B, followed by corner D, to
complete the installation of
the corners.
Step 3
Once all corners are inserted,
press one silicon edge into
channel from corners and
work toward the center.
Make sure welt is fully inserted
into channel. Continue until
all sides are done. Smooth
out edges of graphic.
Graphic: To Ensure Proper Fit
It is important to first insert
graphic into each alternate
corner then to the sides of
the frame. If this is not done,
graphic will not fit into the
frame correctly.
Corner A
Corner D
Corner B
Corner C