36
3.14. CONTROLLER
UNIT
·
Only QUALIFIED SERVICE PERSONNEL should carry out these procedures.
·
During daily cleaning and maintenance, check the surface of the control unit (Gun
Controller) for cracks and other damage and ensure that screws are securely
fastened. Loose screws, cracks, and other damage could cause harm to players and
other customers if left un-repaired.
·
In order to prevent an electric shock and short circuit, be sure to turn power off before
performing work by touching the interior parts of the product.
·
Be careful not to damage the wires. Damaged wires may cause electric shock or short
circuit or present a fire risk.
·
Be very careful when soldering. Handling a soldering iron carelessly may result in a fire
or a burn.
·
When securing the plastic-made parts, do not excessively fasten screws and nuts.
Failure to observe this may damage the parts and cause injury due to fragments
resulting from damage.
In the cases where the gun's operation is not satisfactory or the gun sight deviates from the direction in
which the control unit is pointed, the gun's interior parts may have been damaged. Replace the parts by
disassembling the gun in the following procedure: Also, be sure to perform sighting check in the test mode
when the gun parts are replaced.
3.14.1.OPERATION
Содержание Virtua Cop 3 Deluxe Type
