Sega Saturn Taget Box, Руководство пользователя

Страница: 32 / 49

S T - 1 7 4 - R 2 - 0 9 0 2 9 4
SEGA Enterprises, Ltd.
(RDJ, 7/18/94)
19
ICE Environment Settings
Connect the E7000 and accompanying interface cable to the POD.
The installation and operation method of ICE hereafter are listed in the manual
belonging to ICE and the debugger. Be sure to do the settings for the operating mode
after installation. An example of a setting is shown below. For more information,
see Hitachi Microcomputer Support Hardware SH7604 Emulator User's Manual,
SH-2 Operating Mode Settings, and MODE.
Example of Operating Mode Setting (for Programming Box/Graphics Box)
<When Master Side is ICE>
:
MODE ; C (RET)
E7000 MODE (MD5 - 0) = xx? 0E (RET)
MODE SET (C:CONFIGURATION/U:USER/M:MASTER - SLAVE) = X? C (RET)
CONFIGURATION WRITE OK? (Y/N)? Y (RET)
<When Slave Side is ICE>
:
MODE ; C (RET)
E7000 MODE (MD5 - 0) = xx? 2E (RET)
MODE SET (C:CONFIGURATION/U:USER/M:MASTER - SLAVE) = X? C (RET)
CONFIGURATION WRITE OK? (Y/N)? Y (RET)
The underlined portions must be input. The above setting sets the operating mode
(0E or 2E) and registers it in the configuration file. After installation, once
registered, the operating mode is automatically read from the configuration file and
set. Therefore, the above procedure no longer is required.
Caution : Please read the "Power ON/OFF" procedure in section 2.6 for how to turn on the ICE
unit and Target Box power supplies.